Metal Working Tips

Below points 1 & 2 are a typical switchboard X section of a internal wall and face. Normally parts 1 & 2 are stitch welded together ...

At times you would like to have a fold in a specific place though it is impossible to fold it. The solution is to groove it. If you have a...

If you have to fold a lot of little parts (width under 100mm), the best way to fold them is to have then nested using micro joints (0.5mm n...

98% of CNC press brakes have never been set properly when installed. Specifically in relation to bend angles.  "Do you need to put in ...